Introduction

• The remote electromagnetic flow meter can be corrected in sections.
• There is a shortcut menu, which is convenient for customers to set up quickly.
• The zero point is automatically corrected.
• The low-frequency rectangular wave excitation is not affected by power frequency and various on-site stray interference, and the operation is stable and reliable.
• This remote electromagnetic flow meter can conduct two-way flow measurement and two-way total accumulation; It is not affected by the direction of the fluid and can be accurately measured when installed in both directions.
• Special infrared button is a tool for parameter design and operation of electromagnetic flowmeter without opening the cover.
• The internal resistance of electrode signal can be accurately measured with constant current source fluid resistance measurement under the condition of long wire transmission. It can be used not only to judge whether the fluid in the sensor is empty, but also to identify abnormal phenomena such as electrode contamination and coverage, and provide users with fault processing information such as electrode cleaning.
• It can switch between Chinese and English.

Application

Electromagnetic flow meter often meet this typical problem areas:
• high-vibration lines with integrally mounted transmitters
• warm-climate installations in direct sunlight
• outdoor installations in cold climates.

Remote type flow meter will protect the transmitter far away from the harsh environment and ensure a stable value.

 

---

 

PARAMETERS

• Diameter Nominal: DN10~DN600 

• Ingress protection: IP65

• Electrical conductivity: Water 20μS/cm other medium 5μS/cm 

• Ambient Temperature: -10℃~60℃ 

• Medium Temperature: Integral type: -10℃~120℃

• Electrode material: Stainless steel SUS316, Hastelloy C, Titanium,Tantalum Platinum-iridium 

• Liner material: PFA,F46,Neoprene,PTFE,FEP 

• Accuracy: ±0.5%, ±2mm/s(flowrate<1m/s)

• Nominal Pressure: 0.6~4.0MPa

 

---

 

FEATURE

1. 304 stainless steel, containing more than 18% chromium, more than 8% nickel content

2. =< DN150, adopt seamless pipe, strong pressure resistance

3. Flange selection GB/ANSI/JIS/DIN optional

4. Spray paint(thickness of the paint surface exceeds 90um)

5. Pure copper coils to ensure a stable magnetic field

6. Each flow meters will be calibrated and tested before shipment, and the test report will be keep for three years.

---

 

 

ADVANTAGE

• They are non-obstruction type of flow meters.

• No pressure loss.

• The pipe is surrounded by electromagnet which produces magnetic field.

• The fluid flowing through pipe is conducting type.

• No obstruction is created to flow.

• It is mainly suitable for hydraulic solid transport.

• It is unaffected by changes in temperature, density, viscosity, concentration and electrical  conductivity.
  

---

 

DISADVANTAGE

• It is not suitable for low velocity.

• Gas inclusion cause errors.